Directional Slope Maps (Show Directional Slope Map)

Overview

A single slope map tells you how steep the ground is, but not which way it falls. For a solar layout the direction matters: in the northern hemisphere a north-facing slope needs wider row spacing and loses yield, an east-west slope limits what a tracker row can follow, and a south-facing slope usually helps. South of the equator, read north and south the other way round.

With the directional slope map on, PVX.AI draws three extra maps next to the terrain: north-facing slopes, south-facing slopes and east-west slopes, each coloured by your slope ranges and each with a summary table of how much of the site falls in every range.


Prerequisites

None beyond a terrain source to import. The setting lives in the import wizards, so turn it on before you build the terrain. If the terrain is already built, turn the setting on in any import wizard: the maps appear the next time you import or grade.

Step-by-Step Guide

1. Open any terrain import wizard

On the Terrain Import panel, open Import KML/KMZ, Import LAS/LAZ, Import TXT/CSV or Import Contours.

2. Go to the Terrain Settings tab

Click the Terrain Settings tab at the top of the wizard. The settings on it are saved with the project and apply to every terrain operation.

3. Turn on the directional slope map

Switch on Show Directional Slope Map (EW/NS).

4. Set the slope ranges

Under Slope Analysis Ranges, edit the Min Slope (%), Max Slope (%) and Color of each band. Set the breakpoints at the limits that matter for your rack type, for example the maximum north-south slope your tracker supplier allows. Reset to Defaults restores the standard ranges.

5. Build the terrain and read the maps

Go back to the Import tab and finish the import. The directional maps are drawn beside the terrain on the PVXAI_DirectionTerrain layer, with their tables below them. Compare the north-facing map with your PV Area boundaries before you place racks.


Tips & Recommendations

  • Grading redraws the directional maps and the slope legend for the graded surface, so you can check that the targets were met. After Reset Terrain they still describe the graded surface until you grade or import again.
  • To read slopes for one part of the site only, use Create Specific Legend on the Civil sub-tab. It counts only the terrain inside the closed polyline you pick. See Contours and Spot Elevations.
  • Use the same breakpoints you will enter as grading targets, so the maps before and after grading are directly comparable.

Related