Rack Cross-Section View (Setout)

Overview

Generate Cross-Section draws a section through the terrain and the racks along a line you pick. Each section shows the original and current ground, the piles with their above-ground reveal and embedment, the clearance under the structure, and for trackers the torque tube. Use it to see a problem Collision Analysis reported, or to produce setout sections for the structural team. On tracker sites it can also draw a section for every row in one run.


Prerequisites

Terrain in the drawing and racks placed on it.

Step-by-Step Guide

1. Start the command

On the Layout panel, click the arrow under Collision Analysis and choose Generate Cross-Section. On a drawing with placed trackers and no fixed racks, the command line asks Section: [Single/All]. Press Enter for Single, or type All for the batch in step 4.

2. Draw the section line

Pick the start point and the last point of the section. Draw it across the rows to see a tracker or fixed table from the side, or along a row to see consecutive tables and where they meet. The line is marked in plan with a section name.

3. Choose the view and place it

At Select view type [Front/Cross], choose Front (default) to draw the full rack geometry, or Cross for a simplified outline of the racks. Then pick an empty spot in the drawing where the section should go.

4. Draw all sections at once (trackers)

With All, select a polygon that contains the racks, enter the first section number, and pick the top-left corner of the section grid. PVX.AI draws a section for every row in one run, stacked and ordered north to south. Vertical dimensions are to scale; the spacing between racks is compressed so the sheet stays readable.

5. Read the dimensions

Each pile carries its reveal (front and back reveal on fixed tables) and embedment. The structure shows clearance, with min and max clearance, and for trackers the clearance swept at the maximum angle. Terrain-following cuts show the torque tube, the pile-head bearings and how much the frame bends at each joint. Compare the numbers with your limits, or with Collision Analysis results.


Tips & Recommendations

  • Sections are drawn on the PVXAI_SectionDrawings layer, so you can freeze or plot them separately.
  • For a terrain-only profile without racks, use Civil sub-tab > Earthworks > Generate Terrain Profile.
  • If a section shows piles out of range, fix them with Collision Analysis or Adapt Terrain to Pile and draw the section again.

Related