Importing Point Cloud (Drone) Data

Overview

Import LAS/LAZ builds the terrain from a drone or LiDAR point cloud. This is the most accurate terrain source PVX.AI accepts, and the one to use for detailed design, grading and pile lengths. LAS 1.2, 1.3 and 1.4 and LAZ files are supported. Other point cloud formats (for example E57) are not: convert them to LAS or LAZ first.


Prerequisites

A LAS or LAZ file. If the file header carries no coordinate system, know which one the survey was delivered in. A site boundary is optional.

Step-by-Step Guide

1. Open the wizard

On the Terrain Import panel, click Import LAS/LAZ. The wizard has three steps: File, Boundary and Terrain.

2. Choose the file

On the File step, pick the LAS or LAZ file. PVX.AI reads the point cloud and shows the file name and point count. Click Next →.

3. Confirm the coordinate system

On the Boundary step, the Coordinate System section shows the system Detected from LAS header. If the header has none, click Pick coordinate system… and choose the survey’s system. Use Change if the detected one is wrong.

4. Choose a boundary (optional)

Pick one of these, or leave both empty:

  • Import boundary file…: load a KML or KMZ boundary if the drawing has none yet. It is drawn on the PVXAI_KML_Boundary layer.
  • Select area in drawing: pick a boundary polyline already in the drawing.

With a boundary, only points inside it are sampled. Without one, PVX.AI meshes all points inside an automatic boundary. Use a boundary when the survey covers more than the site, so the terrain stays light.

5. Set the grid resolution and create the terrain

On the Terrain step, set Grid resolution (1 to 25 m, default 3 m) and review the Summary: file, points, grid resolution, output cells and coordinate system. Click Create Terrain.


Tips & Recommendations

  • Which grid resolution: 1 to 3 m keeps the detail a drone survey gives you, which matters for pile lengths and grading. On very large sites, 5 m keeps the drawing responsive. A grid finer than the point spacing of the survey adds no detail and makes the mesh heavier.
  • Give PVX.AI a ground-only (bare earth) cloud. Export it from your survey processing software with vegetation, buildings and equipment removed, so the terrain is the ground you will build on.
  • Survey in US survey feet or international feet: the horizontal coordinates are converted to metres, but elevations are taken from the file as they are. Convert the elevations to metres before importing, or check the terrain levels right after the import.
  • Set directional slope maps and slope ranges on the Terrain Settings tab before you click Create Terrain.
  • If the drawing already has terrain, the grid resolution is locked to the existing terrain’s value so the two surfaces join cleanly.

Related