Extending the Terrain Area

Overview

To cover more ground than your first import, for example an added parcel, a substation plot or an access route, run a Terrain Import wizard again over a new boundary. The new surface is added to the drawing alongside the existing terrain, in the same AutoCAD coordinate system.

There is no separate image-elevation tool any more. Every importer on the Terrain Import panel can extend the terrain: Import KML/KMZ, Import LAS/LAZ, Import TXT/CSV and Import Contours.


Prerequisites

A drawing with terrain already imported, and a closed boundary polyline (or a KML/KMZ file) for the area to add.

Step-by-Step Guide

1. Draw or import the new boundary

Draw a closed polyline around the area to add, or prepare a KML/KMZ of it.

2. Choose the importer

Pick the importer that matches the data you have for the new area:

  • No survey yet: Import KML/KMZ fetches elevation data for the polygon.
  • Drone or LiDAR survey: Import LAS/LAZ.
  • Point file: Import TXT/CSV.
  • Survey linework in the drawing: Import Contours.

3. Run the wizard over the new boundary

Go through the wizard as usual and select the new boundary as the area. With Import KML/KMZ, answer No when asked Delete previous KML?, so the polygons of the first import stay in the drawing.

4. Keep the grid resolution

With Import LAS/LAZ, Import TXT/CSV and Import Contours, the grid resolution is locked to the existing terrain’s value, so both surfaces share one grid. With Import KML/KMZ, enter the same value you used the first time.


Tips & Recommendations

  • Extend the terrain before grading. If you have graded already, extend first and then grade again, so the earthworks see the whole surface.
  • Global elevation data from a KML import is coarser than a survey. If the main site was built from a drone survey, use survey data for the extension too where you have it.
  • After extending, use Create Specific Legend on the Civil sub-tab to read slopes for the new area only. See Contours and Spot Elevations.

Related