Overview
A tracker spec in PVX.AI describes one single-axis tracker table: the module chain, the rotation limit, the height, the torque tube and the piles. In the simple workflow the Rack Design block stays in Automatic mode and PVX.AI spaces the piles evenly. This covers most standard trackers. Use the detailed design when you need to copy a vendor pile drawing with uneven spans and motor gaps.
Prerequisites
The PV module, from the catalog or created as a custom module. The tracker datasheet (module count per tracker, rotation limit, tube size).
Step-by-Step Guide
1. Choose the tracker type
Go to Database > Products > Racks and click Create Tracker. Pick one of three cards:
- Single Row: one rigid torque tube with its own motor. The usual choice.
- Multi-row: one motor drives two or more linked tables through a drive shaft.
- Terrain Following: a chain of jointed segments that bends to follow the ground.
Tracker Settings opens. The form adapts to the type you picked; this guide covers the fields every type shares.
2. Select the module and set the Basic Design
Click Select Module. Then set Name, Pile Profile, Default Color, Module Orientation, Max Angle (°) (the rotation limit each way), Columns (modules along the tube) and Rows (modules across the tube, 1 for a 1P tracker, 2 for 2P).
In Module Place Design, Along-Axis Spacing is the gap between modules along the torque tube and Cross-Axis Spacing the gap between module rows across it (not used when Rows is 1).
3. Set the piles and height
With the Rack Design block on Automatic, set Number of Piles and Distance Between Piles. Set Ground Clearance, the height of the module’s lowest edge above flat ground when the table is rotated to its maximum angle. Height Top is calculated from it: the highest edge at the same angle. The ? button next to it opens a side profile diagram.
4. Describe the torque tube
Tick Model torque tube and enter Diameter, Top Gap (tube top to module underside) and Bottom Gap (pile top to tube bottom). Set Tube Extension, Left and Tube Extension, Right for how far the tube runs past the first and last module. These values change the table length, the pile reveals and the clearances, so use the vendor’s numbers. Details are in Torque Tube and Pile Schedule.
5. Motor and embedment
Click Motor Spacing(s) to set where the motor sits along the table (it defaults to the middle). Set Underground Pile Depth to the embedment length.
6. Save
Click Save. The tracker appears under Tracker Racks in the Racks window.
Tips & Recommendations
- Ground Clearance is a flat-ground design value. On real terrain, check clearance and pile reveals with Collision Analysis after placement.
- The Mirror button in the Rack Design header flips the spec end to end: the motor and any uneven pile spacing move to the other end.
- Choose Terrain Following only when the hardware really articulates. A rigid tracker on rolling ground is handled by grading or Adapt Terrain to Pile.
- Leave Tube Extension at 0 only if the tube really ends at the last module.
