Multi-Row Tracker Groups

Overview

In a multi-row tracker, one motor drives two or more neighbouring tables through a drive shaft. Because the shaft links them, the tables cannot be placed, moved or levelled independently: their tubes have to stay close enough in height and slope for the shaft to turn. PVX.AI treats the group as one object through placement, editing, collision checks and the BoQ.


Prerequisites

A PV module in the database, terrain loaded in the drawing, and the vendor’s data for the group: tables per motor, gap between tables and the shaft’s bend and skew limits.

Step-by-Step Guide

1. Create the spec

Go to Database > Products > Racks, click Create Tracker and pick the Multi-row card. For a terrain-following multi-row tracker, pick Terrain Following instead and tick Multi-row trackers in its section. Fill in the module, Basic Design, torque tube and Rack Design as for any tracker.

2. Set up the group

In the Multi-row group section:

  • Tables per Group: how many tables one motor drives. It starts at 2.
  • Gap Between Linked Tables: the clear east-west gap between two tables of the group, frame edge to frame edge. The drive shaft spans it.
  • Motor Table: which table carries the motor, counted from west to east.
  • E-W Shaft Bend Limit γ (%): how far the shaft may bend between two linked tables, which follows from the height difference of the two tube axes.
  • N-S Tube Skew Limit β (%): how much the north-south slopes of two linked tubes may differ.

Click Save.

3. Place the groups

Build Layout places each group’s tables together with the drive shafts drawn between them. The shaft limits are checked during placement. If a group cannot fit all its tables, it is placed with fewer and the deviation summary says how many groups were short.

4. Move and edit

Move Racks moves a whole group as one rigid unit, and a table’s drive shafts always move with it.

5. Check with Collision Analysis

Collision Analysis judges a group as one unit. Its members show the family Multi-row member, and the suggested fix is either one shared vertical shift for the whole group or group grading required when no shift can satisfy every table.


Tips & Recommendations

  • Check the group settings before placing a large site; after placement every group moves as one.
  • Group members are held in place when Adapt Terrain to Pile re-seats tracker rows, because a shared shaft cannot follow a different tilt on each table. Fix them by grading.
  • The BoQ lists drive shaft spans and cardan joints (two per shaft span) as separate items.

Related