Overview
Roads keep racks off access routes, act as a reference when you place racks with Draw Alignment, and are used for trench routing and device placement. PVX.AI has three kinds of road:
- Manual roads, drawn or converted on the Site Layout panel. This guide covers them.
- Boundary and service roads, made by Build Layout: the Boundary Road ring around each PV area and the corridor roads between rack blocks.
- Generated roads, routed over the graded terrain from your site entrances by the Generate roads option in the Grading window.
Prerequisites
A drawing with PVX.AI loaded. If terrain is loaded, roads are also draped on it in 3D. To convert, draw the road centerline first as a line, arc or open polyline.
Step-by-Step Guide
1. Open the Road dropdown
On the Site Layout panel, clicking the face of the Road button starts Draw Road. The arrow lists Draw Road, Convert to Road, Rebuild Roads and Road Setback.
2. Give the centerline
With Draw Road, pick the points of the road centerline and press Enter to finish. With Convert to Road, select lines, arcs or open polylines you already drew; each one becomes a road. A road is always built from an open centerline, so closed polylines are skipped with a message. For a ring road around the site, use Boundary Road in Build Layout.
3. Answer the three prompts
- Enter road width: the paved width. The default is 5 m.
- Enter inner corner radius: the radius of the inside edge at each bend. The centerline radius is this value plus half the width. Enter 0 for sharp bends.
- Enter rack setback: the clear distance Build Layout keeps between racks and the road edge. The default is 3 m.
The prompts use the drawing unit, so a feet drawing asks in feet. Press Escape at any prompt to cancel with nothing changed.
4. Review the road
PVX.AI draws the road outline around a cyan centerline, rounds every bend, rounds the inside corners where two manual roads cross or meet, drapes the outline and centerline on the terrain, labels the road (RO-1, RO-2 and so on) and fills all roads with one merged hatch. The whole conversion is one undo step.
5. Build the layout
Build Layout keeps racks out of each road plus its rack setback. Where two roads meet, the rounded corner uses the larger setback of the two. If a road was edited since it was built, Build Layout asks whether to Rebuild roads, then build, Build anyway or cancel.
Tips & Recommendations
- To reshape a road, edit its cyan centerline and run Rebuild Roads. See Editing Road Centerlines below.
- To change how far racks stay from a road, use Road Setback. The road is not redrawn; build the layout again to apply it.
- Roads drawn before per-road setbacks existed, and roads with no stored value, use the 3 m default.
- On tracker sites with corridors switched on, Build Layout still makes its corridor service roads when a manual road crosses the PV area. A corridor road may cross the manual road but never runs along it.
- Generate Trenches from Roads, in the Trenches dropdown on the Electrical sub-tab, routes trenches along the roads you defined.
