Overview
PVX.AI has three quick checks that show problem racks directly in the drawing while you lay out a site: overlapping tables after a 2D layout is brought into 3D, rack coloring by terrain slope, and highlighting of piles longer than your limit. They take seconds and need no settings beyond a few numbers. They do not measure clearance along the row or propose fixes; for that, run Collision Analysis.
Prerequisites
Terrain in the drawing, and racks placed with Build Layout or brought in with Import Layout.
Step-by-Step Guide
1. Check overlaps when importing a 2D layout
When you convert a 2D layout with Layout > Import > Import Layout, enter the slope limits (N (%), S (%) and EW (%)). Tables standing on ground steeper than these limits are not converted, and the command line reports how many were skipped per polygon. Tables that overlap a neighbour once they are projected onto the terrain are drawn in pink. Move, delete or re-place the pink tables before you continue.
2. Color racks by slope
Open Layout > Tools > Rack Slope Analysis. Choose the direction (North-South or East-West), enter a Min and Max in degrees and click Apply. Racks are colored by the terrain slope under them, so steep zones stand out. Clear restores the normal colors.
3. Highlight piles that are too long
In Configurations > Settings, open Pile Length Limits, tick Enable pile length limit highlighting, and enter a Max Length and Color for each pile type (Front, Back, Middle, Single). Piles longer than their limit are drawn in that color, and the highlight refreshes when racks are placed.
4. Decide whether you need Collision Analysis
The quick checks are enough while you are still testing layouts. Switch to Collision Analysis when:
- you need ground clearance checked along the full row, including humps between piles;
- you work to a pile reveal band (minimum and maximum), not only a maximum length;
- you want PVX.AI to fix the racks by lifting them, grading or adapting the terrain;
- you need a pile schedule and report for a structural review.
Tips & Recommendations
- Overlaps after import usually mean the 2D layout was drawn too tight for the terrain. Check the row spacing in the source drawing.
- Many skipped tables in one area point to grading. Run Terrain Grading on that area and import again.
- Turn pile highlighting off before plotting if you do not want the colors on the drawing.
