Overview
To cover more ground than your first import, for example an added parcel, a substation plot or an access route, run a Terrain Import wizard again over a new boundary. The new surface is added to the drawing alongside the existing terrain, in the same AutoCAD coordinate system.
There is no separate image-elevation tool any more. Every importer on the Terrain Import panel can extend the terrain: Import KML/KMZ, Import LAS/LAZ, Import TXT/CSV and Import Contours.
Prerequisites
A drawing with terrain already imported, and a closed boundary polyline (or a KML/KMZ file) for the area to add.
Step-by-Step Guide
1. Draw or import the new boundary
Draw a closed polyline around the area to add, or prepare a KML/KMZ of it.
2. Choose the importer
Pick the importer that matches the data you have for the new area:
- No survey yet: Import KML/KMZ fetches elevation data for the polygon.
- Drone or LiDAR survey: Import LAS/LAZ.
- Point file: Import TXT/CSV.
- Survey linework in the drawing: Import Contours.
3. Run the wizard over the new boundary
Go through the wizard as usual and select the new boundary as the area. With Import KML/KMZ, answer No when asked Delete previous KML?, so the polygons of the first import stay in the drawing.
4. Keep the grid resolution
With Import LAS/LAZ, Import TXT/CSV and Import Contours, the grid resolution is locked to the existing terrain’s value, so both surfaces share one grid. With Import KML/KMZ, enter the same value you used the first time.
Tips & Recommendations
- Extend the terrain before grading. If you have graded already, extend first and then grade again, so the earthworks see the whole surface.
- Global elevation data from a KML import is coarser than a survey. If the main site was built from a drone survey, use survey data for the extension too where you have it.
- After extending, use Create Specific Legend on the Civil sub-tab to read slopes for the new area only. See Contours and Spot Elevations.
